[Oct-2021] Get 100% Real NS0-176 Exam Questions, Accurate & Verified BraindumpsPrep Dumps in the Real Exam!
Pass Your Cisco and NetApp FlexPod Exams Fast. All Top NS0-176 Exam Questions Are Covered.
NEW QUESTION 66
You are asked to install the Virtual Supervisor Module (VSM) software on a Nexus 1000v switch.
Which two sources would you use to install this software? (Choose two.)
- A. PXE boot
- B. VSC plug-in
- C. ISO image
- D. OVA file
Answer: A,C
NEW QUESTION 67
Exhibit:
An administrator is building a FlexPod configuration with UCS 6296 Fabric Interconnect devices that support legacy Fibre Channel 9FC) connections. The administrator uses UCS Manager to configure the unified ports on the Fabric Interconnect.
Referring to the exhibit, how many ports will FC use after the configuration is completed?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 68
Refer to the exhibit.
What management tool may be used for creating virtual machines?
- A. System Center Virtual Machine Manager
- B. MMC
- C. System Center Orchestrator
- D. Hyper-V Manager
Answer: D
NEW QUESTION 69
To install your VEM, what is the extension of the VEM file name you'll be looking for to complete this install?
- A. .vib
- B. .vsm
- C. .vem
- D. .zip
Answer: A
NEW QUESTION 70
An administrator is configuring a Flexpod Datacenter solution. The UCS service profiles will use FCoE connectivity to the NetApp cluster.
Which pool is needed to configure the vHBA templates?
- A. IQN pool
- B. MAC pool
- C. WWPN pool
- D. WWNN pool
Answer: C
NEW QUESTION 71
Which two statements about HA pairs in a NetApp cluster are true? (Choose two.)
- A. HA pairs in the same chassis are not connected to each other through an HA interconnect.
- B. In the event of a storage failover, the surviving node always takes over the partner's data LIFs.
- C. In the event of a storage failover, the surviving node provides read/write access to the partner's disks until the failed node becomes available again.
- D. Non-disruptive aggregate relocation can be performed between HA pairs without a takeover and giveback.
Answer: B,C
NEW QUESTION 72
NetApp recommends that your SSL key length be?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 73
Which backup type stores Service Profile information as a small editable file?
- A. Full Backup
- B. All Configurations
- C. System Configuration
- D. Logical Configuration
Answer: D
NEW QUESTION 74
When installing an instance of VMware ESXi on a UCS B-Series server, where should an ISO image be loaded?
- A. ISO images should not be used
- B. The UCS vCenter Plugin must be used
- C. Only physical install disks are supported on UCS B-Series servers
- D. From the UCS Manager select KVM Console, Select the Virtual Media tab, and select Add Image
Answer: D
NEW QUESTION 75
With Clustered Data ONTAP, which three protocols are supported for host boot in a UCS stateless computing environment in the FlexPod configuration? (Choose three.)
- A. CIFS
- B. NFS
- C. FCoE
- D. FCIP
- E. iSCSI
- F. FC
- G. iFCP
Answer: C,E,F
NEW QUESTION 76
A customer uses Cisco Intersight and now wants to monitor their NetApp storage system with Intersight.
In this scenario, which three actions must be completed to accomplish this task? (Choose three.)
- A. Activate the API Gateway in Active IQ Unified Manager.
- B. Get an Intersight Advantage tier license.
- C. Activate the API Gateway in ONTAP System Manager.
- D. Get an Intersight Essentials tier license.
- E. Deploy Active IQ Unified Manager.
Answer: A,B,E
NEW QUESTION 77
You are asked to increase read performance for a single aggregate; however, there are no PCI-e slots available in the NetApp cluster nodes.
In this scenario, which feature meets these requirements?
- A. Flash Cache
- B. Advanced Drive Partitioning
- C. Thin Provisioning
- D. Flash pool
Answer: D
NEW QUESTION 78
You want to verify that you have configured Multipath HA correctly for all of the attached disk shelves on a NetApp cluster.
Which two commands would you execute from the cluster CLI prompt to accomplish this task? (Choose two.)
- A. node run -node * -command disk show
- B. node run -node * storage show disk -p
- C. node run -node * sysconfig -a
- D. sysconfig -a
Answer: B,D
NEW QUESTION 79
To support Storage Virtual Machines, which type of unique login account must be created?
- A. vsadmin, for the cluster
- B. vsadmin, for each Storage Virtual Machine
- C. admin, for the cluster
- D. admin, for each Storage Virtual Machine
Answer: B
NEW QUESTION 80
Which two are correct about VSAN configuration within UCS Manager? (Choose two)
- A. VSAN ID and FCoE VLAN ID have to match.
- B. In addition to SAN tab, VSANs can be configured under UCSM Server tab as well.
- C. VSAN IDs 3840-4079 are not available regardless of the Fabric Interconnect mode.
- D. VSAN can be configured as fabric interconnect specific.
- E. We can delete VSAN 1.
- F. VSAN can be configured as a global parameter.
Answer: D,E
NEW QUESTION 81
What is the correct flow control setting for the intercluster ports on a NetApp cluster?
to 50% cashback.
- A. switched cluster = none switchless cluster = none
- B. switched cluster = set to match the setting on switch port switchless cluster = none
- C. switched cluster = none switchless cluster = full
- D. switched cluster = full switchless cluster = none
Answer: B
NEW QUESTION 82
A Cisco UCS system is operating in FC End-Host Mode. The fabric Interconnects are uplinked into Nexus 5672UP switches using native FC. The service profiles are unable to boot from SAN using FC.
When executing the show flogi database command on the Nexus switches, only the Fabric Interconnect port WWNs are visible. No service profile WWNs are shown.
What caused this issue?
- A. The zoning on the Nexus switches is incorrect.
- B. The Nexus switches do not have NPIV enabled.
- C. The Nexus switches do not have NPV enabled.
- D. The Nexus must be configured for FCoE instead of native Fibre Channel.
Answer: B
NEW QUESTION 83
Exhibit:
An administrator has a FlexPod solution configured for Microsoft Hyper-V 2012 R2. The UCS blade servers are configured for SAN boot, and all zoning and LUN mapping for a single 50 GB LUN have been configured.
When selecting the install disk during the Windows installation, the symptoms and error shown in the exhibit are displayed.
What should the administrator do to solve the problem?
- A. Delete the extra LUNs that were created.
- B. Install the Cisco VIC storage miniport driver for Windows 2012 R2.
- C. Configure a single path to the LUN for the duration of the Windows installation process.
- D. Change the LUN OS type to oeWindows 2008 or later.
Answer: B
NEW QUESTION 84
Which is a valid connectivity option for a FlexPod?
Note some of these may also be 'valid' options outside of a FlexPod architecture but do not specifically meet FlexPod scalability and availability requirements.
- A. UCS C-Series direct attach FAS
- B. UCS B-Series > 2232PP FEX > UCS FI > Nexus 5548 < FAS
- C. UCS C-Series > 2232PP FEX > UCS FI > Nexus 5548 < FAS
- D. UCS B-Series direct attach FAS
- E. UCS C-Series > Nexus 3048 < FAS
- F. UCS B-series > UCS FI > 2232PP FEX > Nexus 5548 < FAS
- G. UCS B-Series > UCS FI > Catalyst 3750 < FAS
Answer: C,E
NEW QUESTION 85
Exhibit:
Your customer has a FlexPod VMware solution deployed with NFS datastores. As shown in the exhibit, the links between the Fabric Interconnects and storage controllers are single-mode interface groups with autorevert set to true, hosting a single access LIF. NFS I/O is currently going through fabric A to ST-A. The customer wants to use both fabrics for NFS I/O.
In this scenario, what will accomplish this task?
- A. Configure VMware hosts to utilize an NFS LIF on ST-B that is connected to fabric A.
- B. Configure VMware hosts to use a new datastore with an NFS LIF on ST-B connected to fabric B.
- C. Add two physical links between SW-A and SW-B.
- D. Migrate the existing LIF that is used for NFS I/O on ST-A to its HA partner ST-B.
Answer: B
NEW QUESTION 86
......
Penetration testers simulate NS0-176 exam: https://www.briandumpsprep.com/NS0-176-prep-exam-braindumps.html
